Installing low voltage wiring

We install audio wiring for background music in franchise businesses, multi-room audio systems and paging speaker systems.

We also install wiring for alarm systems, computers, TVs or other video systems and many other applications.

WIRED handles all commercial jobs for both new construction and retrofitting older existing office spaces. X Close Panel. Advantages of Structured Cabling Structured cabling provides simpler management and more flexibility within your system leading to a higher ROI for your franchisees. Please enable scripts and reload this page.

Turn on more accessible mode. Turn off more accessible mode. Skip Ribbon Commands. Skip to main content. Turn off Animations. Turn on Animations. How Do I Find? How Do I Pay? History Library Maps Schools. Search for department, service, or keyword. With respect to electrical lighting fixtures and devices, the replacement is with a fixture or device having the same voltage and the same or less amperage.

The work is performed by a person licensed under G. Most transformers are rated to handle loads ranging from to watts. A higher rating indicates a longer wire and, as a result, more light fixtures that may be connected to the system. Purchasing a complete new system in a landscape light kit may be more cost-effective than purchasing only a new transformer.

Cable Length FT Max. Cable Length FT 88 watts watts watts watts watts not recommended watts not recommended 2 separate runs 2 separate runs watts not recommended 2 separate runs 2 separate runs watts not recommended 3 separate runs 3 separate runs Check to see whether your wire and connections are listed for direct burial, which improves the prevention of corrosion and other weather-related issues over time.

A wood screw may be used to install most types of siding. Use screws that are long enough to penetrate the sheathing beneath the siding. For masonry, drill a hole for a lag shield, then screw it into the shield. Another alternative is to install the transformer on a wooden pole near your house.

Do not connect the transformer just yet. Assemble and Position the Lights Low voltage light fixture kits are often self-assembly items. Follow the directions provided by the manufacturer. For path lights, measure a specific pattern between the units and set them on the ground temporarily. Extend the cable from the transformer along the route of the fixtures you just mounted.

Make sure to keep the wire above ground. Connect the Lights Make sure to leave around 18 inches of slack at each fixture before making the electrical connections. This will allow you to change or alter the fixture placement later if necessary. Begin by removing an inch of insulation from the wires coming from the fixture. Then cut the cable, split the conductors, and strip the wires.

Repeat for the second conductor. Insert each wire into heat shrink tubing.